(SKU:ELB060415)3路MOS管场效应管驱动模块 IRF540
来自YwRobot Studio Wiki
简介
采用原装IRF540功率MOS管,可以进行PWM调节输出 可以让Arduino驱动高达24V的负载,如LED灯带、直流马达、微型水泵、电磁阀 用过PWM调可以实现LED无级调光、马达无级调速。
注意:驱动1A以上的负载需安装散热片
产品参数
- 尺寸:69.4*41.7mm
- 固定孔:3mm
- 孔距:2400*1300mil(60.96*33.02mm)
- 电压:3.3V、5V
- 端口:数字量电平
- 输出负载电压:0-24V
- 输出负载电流:<6A (1A以上需加散热片)
- 平台:Arduino、单片机、ARM、树莓派
使用教程
样例代码1
int led1 = 9; int led2 = 10; int led3 = 11; void setup() { pinMode(led1, OUTPUT); pinMode(led2, OUTPUT); pinMode(led3, OUTPUT); } void loop() { digitalWrite(led1, HIGH); delay(1000); digitalWrite(led1, LOW); digitalWrite(led2, HIGH); delay(1000); digitalWrite(led2, LOW); digitalWrite(led3, HIGH); delay(1000); digitalWrite(led3, LOW); }
样例代码2
#define LEDR 9 #define LEDB 11 #define LEDG 10 int i = 0; void setup() { pinMode(LEDG, OUTPUT); pinMode(LEDB, OUTPUT); pinMode(LEDR, OUTPUT); } void loop() { analogWrite(LEDR, 255); analogWrite(LEDB, 255); analogWrite(LEDG, 255); //off analogWrite(LEDR, 0); delay(1000); //hong analogWrite(LEDG, 220); delay(1000); //cheng analogWrite(LEDR, 0); analogWrite(LEDG, 120); delay(1000); //huang analogWrite(LEDR, 255); analogWrite(LEDG, 0); delay(1000); //lv analogWrite(LEDB, 0); delay(1000); //qing analogWrite(LEDG, 255); analogWrite(LEDB, 0); delay(1000); //lan analogWrite(LEDR, 0); analogWrite(LEDG, 255); delay(1000); //zi analogWrite(LEDG, 0); delay(1000); //bai analogWrite(LEDR, 255); analogWrite(LEDB, 255); analogWrite(LEDG, 255); //off for (i = 255; i > 0; i--) { analogWrite(LEDR, i); delay(10); } for (i = 255; i > 0; i--) { analogWrite(LEDG, i); delay(10); } for (i = 0; i < 255; i++) { analogWrite(LEDR, i); delay(10); } for (i = 255; i > 0; i--) { analogWrite(LEDB, i); delay(10); } for (i = 0; i < 255; i++) { analogWrite(LEDG, i); delay(10); } for (i = 255; i > 0; i--) { analogWrite(LEDR, i); delay(10); } analogWrite(LEDG, 0); analogWrite(LEDB, 0); analogWrite(LEDR, 0); }
更多
[YWRobot产品资料下载]